Your Metal Fabricator Across North Jersey

As a metal fabricator North Jersey contractors order from direct, U Design starts every job at our East Orange shop, in the middle of Essex County and minutes from the densest stretch of the state's building market. From there, the shop fabricates standing seam roofing, metal siding, edge metal, custom trim, and soffit and fascia to spec, and gets it to the jobs that need it across the four primary counties and the wider tri-state.

Most of the work stays close to home. Newark, Jersey City, Elizabeth, and Hackensack each sit a short drive from the shop, which keeps delivery practical and on-site forming workable when a run is too long to ship in one piece. Paterson and the rest of North Jersey are an easy reach as well.

Past the core counties, the shop delivers metal anywhere inside roughly 150 miles of East Orange. The point of a local metal fabricator is not proximity for its own sake. It is shorter hauls, fewer hand-offs, and a shop a contractor can actually get on the phone when a job needs an answer.

Buying close also keeps a job consistent. When the roof panels, the wall panels, the edge metal, and the soffit and fascia all come off one shop floor and one coil source, the finishes match across the building, and a second-phase reorder months later still lines up with the first. For a North Jersey trade that runs jobs in sequence, that consistency is worth more than a catalog price from three states away.

The four primary counties are where the shop concentrates, but a metal fabricator North Jersey contractors call on reaches well beyond them. The delivery radius runs about 150 miles out from East Orange in every direction, and inside that line U Design regularly fabricates and ships for contractors, GCs, architects, and owners across the wider region.

The list below is not a marketing flourish. It is the honest edge of where the shop can put metal on a truck on a workable schedule. If a jobsite sits inside it, the address goes on the quote and delivery is priced with the order.

Distance changes one thing: the delivery line on the quote. The fabrication standard, the profiles, the gauges, and the finishes are the same whether the job is four miles away in Newark or near the edge of the radius in the Lehigh Valley.

If a jobsite sits within about 150 miles of East Orange, the shop can deliver. Send the address with the quote and delivery goes on the order.

Metal fabricator North Jersey jobs all pull from the same five lines: standing seam roofing, metal siding and wall panels, edge metal and perimeter trim, custom architectural sheet metal, and soffit and fascia. A roofer in Newark and an architect's job in Hackensack draw on the same shop and the same finished stock, each cut to its own spec.

Because the fabrication happens in one North Jersey shop, a contractor can order the roof, the wall, and the edge package together and have it all arrive color-matched. That is harder to pull off when the panels come from a national distributor and the trim comes from somewhere else, with two lead times and two slightly different whites.

The detail on each line, the profiles, gauges, substrates, and finishes, lives on the services page. This page is about getting that metal to the job, anywhere inside the radius.